The Tech Help You Need

[Ferenc Veres <lion-1NpdDDQuh1mT9ig0jae3mg@xxxxxxxxxxxxxxxx>]

Hi All!

I think there was an option to do this, but actually I can't find it 
anywhere, including the user's manual.

What I need is to draw a little marker in 90 degree between 2 freely 
specified points (using snap of course). I remember there was an option 
to do so, and I could specify the length of the line (negative also), 
then choose 2 points. (Or I was just dreaming.)

           |
a-------------------b

Something like that. :-) I use this to position blocks and other 
elements between 2 existing ones. The only option I can see, is actually 
drawing a line from A to B and use snap to middle point. But this would 
require drawing a lot of extra lines, especially because the lines I 
draw are helper lines too. :-)

(So both ---- and | are helper lines, and position and distance of A and 
B are completely "random", so I cannot use @30,0 etc.)

Any ideas will be welcomed!

Thanks,
Ferenc

(Qcad version 2.0.4.)


------------------------ Yahoo! Groups Sponsor --------------------~--> 
Most low income households are not online. Help bridge the digital divide today!
http://us.click.yahoo.com/cd_AJB/QnQLAA/TtwFAA/_iFolB/TM
--------------------------------------------------------------------~->